If your seal bar is not sealing, there are numerous possibilities:
- Confirm your seal time is set at least to 1.5 seconds.
→ LED Display: How do I setup a program?
→ LCD Display: How do I setup a program? - Reset the safety overload switch (not available on MVS 26X and MVS 31X).
The safety overload switch is a safety feature on your vacuum sealer.
If it has tripped, please contact a qualified technician or electrician. - The vacuum pump is not reaching full vacuum.
Please setup a test program with 75% vacuum and 2.5 seconds seal time.
→ LED Display: How do I setup a program?
→ LCD Display: How do I setup a program?
- If the seal bar has sealed with the test program, please change the pump oil and recalibrate your vacuum sealer.
→ How do I change the oil?
If the seal bar has not sealed with the test program, please run the test program again:
→ If the seal bar does not raise you may have an issue with the bladder assembly, please contact a qualified technician or electrician.
→ If the seal bar does not get hot (please touch it with your hand right after the air return), you may have an issue with the power assembly, please contact a qualified technician or electrician.
- If the seal bar has sealed with the test program, please change the pump oil and recalibrate your vacuum sealer.
Minipack does not assume any responsibility or liability for the advice given and shall not be liable for any direct, indirect, special, incidental or consequential damages in connection with the use of this information.